Skip to content
3627 Stone Way N #203, Seattle, WA 98103Open daily 8AM–8PM
(425) 728-2403
Openers

Garage Door Opener Repair in Seattle, WA

An opener is a motor, a gear set, a circuit board, a drive and a pair of safety sensors, and any of them can fail. The symptoms are familiar: the motor hums but nothing moves, the door starts and reverses, the light flashes, or the remote works from one spot in the driveway and nowhere else.

What to Know About Garage Door Opener Repair in Seattle

Before we touch the opener, we check the door. A door that is out of balance or binding in its track will defeat any opener, and replacing the opener without fixing the door just wears out a new one.

A diagnostic visit with a minor opener repair is the starting price. Gear kits, logic boards and sensor replacements are priced individually, and you approve the total in writing before we start.

We provide garage door opener repair across Seattle and the nearby cities from our office on Stone Way North, and each area page below explains what is typical there, from damp alley garages to three-car Eastside garages.

How We Diagnose an Opener

The door is disconnected and lifted by hand first. If it runs smoothly and stays balanced, the fault is in the opener. From there we read the opener's diagnostic flash codes where the model has them, check the safety sensors' alignment and wiring, the drive gear and sprocket, the chain or belt tension, the travel limits and force settings, and the logic board.

Common repairs include stripped drive gears on chain and belt units, failed capacitors that leave the motor humming, misaligned or failed photo-eyes, worn trolleys, and wall-button or remote problems. We carry parts for the major residential brands, so most repairs are done on the first visit.

Safety Systems on Every Opener

Openers built since the early 1990s must meet UL 325 and the federal entrapment-protection rule, which require photo-eye sensors and automatic reversal. After any opener repair we test reversal against an obstruction and confirm the sensors stop and reverse a closing door.

Repair or Replace the Opener?

Gears, sensors, capacitors, trolleys and remotes are inexpensive and worth replacing. A failed logic board on an opener more than fifteen years old is often the tipping point, because boards for older models are scarce and expensive, and an older unit may lack rolling-code security and modern reversal sensitivity. We give you both prices and let you choose.

Direct answer · pricing

Garage Door Opener Repair in Seattle starts at $149. A diagnostic visit with a minor opener repair is the starting price. Gear kits, logic boards and sensor replacements are priced individually, and you approve the total in writing before we start.

Opener diagnostic and adjustmentTravel limits, force and sensors set and tested
From $149
Drive gear and sprocket kitStripped gears replaced on chain and belt units
From $199
Safety sensor replacementNew photo-eye pair, aligned and wired
From $129
Logic board replacementWhen the board for your model is available
From $249
Capacitor replacementMotor hums but will not start
From $149
Remote and keypad programmingNew remotes, keypad or car-system pairing
From $79

Signs You Need Garage Door Opener Repair

The opener hums but the door does not move
The door starts down, then reverses back up
The opener light flashes and the door will not close
The motor runs but the trolley does not move
Remotes only work close to the door, or not at all
Loud grinding or rattling from the opener unit

How Garage Door Opener Repair Works in Seattle

Every garage door opener repair job follows the same steps, and nothing is started until you approve the written price.

  1. Door check firstThe door is disconnected and lifted by hand to rule out spring or track problems.
  2. Read the openerDiagnostic codes, sensors, wiring, drive, gears and board are checked in order.
  3. Quote and repairYou approve the written price and the faulty part is replaced from stock on the truck.
  4. Program and adjustTravel limits and force settings are set, and remotes and keypads re-paired.
  5. Safety testAuto-reverse and photo-eye sensors are tested against an obstruction before we leave.

Garage Door Opener Repair Across Seattle and Nearby Cities

Each area below has its own garage door opener repair page with local detail.

Seattle neighborhoods

Nearby cities

Garage Door Opener Repair Questions from Seattle Homeowners

How much does garage door opener repair cost?
Opener diagnostics with adjustment start at $149. Gear kits start at $199, sensors at $129 and logic boards at $249 when available. Call (425) 728-2403.
Why does my opener hum but not open the door?
Common causes are a failed start capacitor, stripped drive gears, a broken spring making the door too heavy, or the door being locked manually. We check the door first, then the opener.
Why does the door reverse before it closes?
Usually the safety sensors are misaligned, dirty or blocked, or the close-force setting is too sensitive for a door that has become heavy.
Which brands do you repair?
We repair the major residential brands, including LiftMaster, Chamberlain, Genie, Craftsman and Linear, and wall-mount jackshaft openers.
Is it worth repairing an old opener?
Usually yes for gears, sensors and capacitors. If the logic board fails on an opener more than fifteen years old, replacement is often better value.
Can you program my car to open the garage?
Yes. We pair car systems, keypads and new remotes with compatible openers during the visit.

Book Garage Door Opener Repair in Seattle

Call for a price range on the phone, or send a request and we will confirm a time window during business hours.

(425) 728-2403
Call NowFree Quote