Skip to content
3627 Stone Way N #203, Seattle, WA 98103Open daily 8AM–8PM
(425) 728-2403
Nearby city · 9 mi from our office

Garage Door Spring Repair in Kenmore, WA

A snapped spring can trap a car and make the door dangerous to lift. We carry the common sizes and usually finish the job in one visit, including in Arrowhead.

  • Starts at $249 anywhere in Kenmore, with the full price in writing first
  • Safety-reverse test before we leave

Get Your Free Quote

Written price before any work. We reply during business hours.

Free estimate · You decide after seeing the price

Direct answer · pricing

Garage Door Spring Repair in Kenmore starts at $249. There is no trip fee in our service area, and the price you are quoted in writing is the price you pay. Call (425) 728-2403 for an exact quote.

High-cycle spring upgradeRated for roughly twice the cycles
From $399
Extension spring pair with safety cablesBoth sides replaced, containment cables fitted. Same price in the Moorlands and the Finn Hill edge.
From $229
Single torsion spring replacementDoor weighed, spring sized, balanced and tested
From $249
Pair of torsion springsRecommended on two-spring doors. Same rate across the area.
From $349
Extension-to-torsion conversionNew shaft, drums, bearings and springs
From $549

Why Garage Door Spring Repair Calls Come In from Kenmore

Kenmore sits at the north tip of Lake Washington, where the Sammamish River meets the lake, with hillside neighborhoods rising from the shore. It is quieter and more wooded than its neighbors. In damp garages, springs rust between the coils, and a rusted spring breaks well before its rated cycle count, so spring calls in Kenmore are a steady part of our week.

The weather plays a part: lake-shore fog and damp hillside lots under big trees, with colder mornings than the city in winter. When we replace a spring here, we look at the other spring, the cables and the bottom brackets too, because they have lived through the same winters.

Signs You Need Garage Door Spring Repair in Kenmore

The door closes crooked, with one side lower (a frequent call in Inglewood)
The door slams down quickly when released halfway
One cable is slack or has unwound from its drum (often reported near Saint Edward State Park)
The door feels extremely heavy when lifted by hand
The opener strains and the door lifts only a few inches (especially in the Moorlands)

How Garage Door Spring Repair Works in Kenmore

No step is skipped because the schedule is busy. This is the sequence for garage door spring repair in Kenmore.

  1. Secure the doorThe door is clamped closed and the opener unplugged before any spring work starts.
  2. Weigh and measureThe door is weighed and its height, drum size and existing springs measured to size the new springs correctly. Done the same way near Saint Edward State Park.
  3. Unwind and removeRemaining spring tension is released with proper winding bars, never screwdrivers, and the old springs come off.
  4. Install and windNew springs are fitted, wound to the correct number of turns and the cables re-tensioned evenly on both drums.
  5. Balance and testThe door is balance-tested by hand, rollers and bearings lubricated, and the opener reconnected and safety-tested. No exceptions.

Local Conditions We Work Around in Kenmore

The houses here are 1960s–1980s split-levels and daylight-basement homes on the hillsides, newer infill houses and lakefront properties, and spring setups vary as much as the houses: single and double torsion, extension springs on older doors and low-headroom systems in tight garages.

Hillside driveways here often meet the garage at an angle, and the slab slopes slightly toward or away from the door. That makes a standard bottom seal leave a wedge-shaped gap. A thicker seal, or a seal plus a threshold strip, closes it and stops wind-driven rain from reaching the floor.

No trip fee in our service area, no pressure and no invented problems. Every recommendation is shown to you first, so you can make your own decision. Reach us at (425) 728-2403.

Garage Door Spring Repair Questions from Kenmore

Why did my spring break in cold weather?
Springs often fail on the first cold mornings of the year. Steel is under the most stress then, and a spring that was already near the end of its life gives way. Rust between the coils, common in damp Seattle garages, speeds that up.
How long do garage door springs last?
A standard spring is rated for about 10,000 cycles, which is roughly seven to ten years for a household that opens the door three or four times a day. Heavier use shortens that; high-cycle springs last longer.
Is it safe to lift the door while a spring is broken?
Please do not. Without the spring, the full weight of the door is held by the opener or your hands, and it can drop suddenly. Leave it closed and call us.
How much does garage door spring repair cost?
A single torsion spring replacement starts at $249 and a pair starts at $349, including weighing the door, sizing the springs, balancing and testing. Call (425) 728-2403 for a quote.
Do you provide garage door spring repair near Saint Edward State Park?
Yes. Garage door spring repair is available across Kenmore, including Inglewood, Arrowhead and the Moorlands, with no trip fee within our service area. Call (425) 728-2403 or send the form.
Is there a garage door spring repair company near me in Kenmore?
Yes. We are based on Stone Way North in Seattle, about 9 miles away, and most bookings are scheduled within a day or two.

Book Garage Door Spring Repair in Kenmore

Call now, or send the form above and we will confirm a window that works for your address.

(425) 728-2403
Call NowFree Quote