Skip to content
3627 Stone Way N #203, Seattle, WA 98103Open daily 8AM–8PM
(425) 728-2403
Nearby city · 13 mi from our office

Garage Door Spring Repair in Renton, WA

Broken torsion and extension springs replaced and sized to the weight of your door, not guessed from the old spring. We are about 13 miles from our Stone Way office.

  • Starts at $249 anywhere in Renton, with the full price in writing first
  • Safety-reverse test before we leave

Get Your Free Quote

Written price before any work. We reply during business hours.

Free estimate · You decide after seeing the price

Direct answer · pricing

Garage Door Spring Repair in Renton starts at $249. There is no trip fee in our service area, and the price you are quoted in writing is the price you pay. Call (425) 728-2403 for an exact quote.

Extension-to-torsion conversionNew shaft, drums, bearings and springs. No trip fee.
From $549
Extension spring pair with safety cablesBoth sides replaced, containment cables fitted
From $229
High-cycle spring upgradeRated for roughly twice the cycles. Same price in Benson Hill and Fairwood.
From $399
Pair of torsion springsRecommended on two-spring doors
From $349
Single torsion spring replacementDoor weighed, spring sized, balanced and tested. Same rate across the area.
From $249

Why Garage Door Spring Repair Calls Come In from Renton

Springs carry almost the whole weight of the door, which is why a broken one changes everything at once. Renton sits at the south end of Lake Washington, with wartime housing in the Highlands, newer subdivisions on the plateaus to the east and south, and a long industrial history along the river and the lake. Near Gene Coulon Memorial Beach Park, we replace more torsion springs than any other single part.

The garages we see here are small single doors on the older Highlands houses and attached two-car garages in the subdivisions. Whatever the setup, we weigh the door, size the springs to that weight and the door's height, wind them to the correct turns and finish with a hand balance test.

Signs You Need Garage Door Spring Repair in Renton

The opener strains and the door lifts only a few inches
The door feels extremely heavy when lifted by hand (common in Talbot Hill and Benson Hill)
A visible gap in the coil of a spring above the door
A loud bang from the garage, like a gunshot, with no obvious cause (routine on local jobs)
The door closes crooked, with one side lower

How Garage Door Spring Repair Works in Renton

The steps below are the same on every garage door spring repair visit we make, and the technician will walk you through them on site.

  1. Secure the doorThe door is clamped closed and the opener unplugged before any spring work starts. Standard in Fairwood and Maplewood.
  2. Weigh and measureThe door is weighed and its height, drum size and existing springs measured to size the new springs correctly.
  3. Unwind and removeRemaining spring tension is released with proper winding bars, never screwdrivers, and the old springs come off.
  4. Install and windNew springs are fitted, wound to the correct number of turns and the cables re-tensioned evenly on both drums. Same on every local visit.
  5. Balance and testThe door is balance-tested by hand, rollers and bearings lubricated, and the opener reconnected and safety-tested.

What We See on Renton Jobs

Reaching the spring is not always simple here: flat driveways in most subdivisions and narrower streets in the older neighborhoods. We plan the visit around it so the job takes one trip.

Subdivisions from the 1970s through the 1990s are reaching the age where everything is due at once: original springs, worn rollers, the second opener and a door that has been repainted twice. A tune-up tells you which of those really needs attention now.

Most bookings are scheduled within a day or two, and the price you were quoted is the price you pay. Should the job turn out bigger, you are told and asked before it grows. (425) 728-2403.

Garage Door Spring Repair Questions from Renton

How long do garage door springs last?
A standard spring is rated for about 10,000 cycles, which is roughly seven to ten years for a household that opens the door three or four times a day. Heavier use shortens that; high-cycle springs last longer.
Why did my spring break in cold weather?
Springs often fail on the first cold mornings of the year. Steel is under the most stress then, and a spring that was already near the end of its life gives way. Rust between the coils, common in damp Seattle garages, speeds that up.
How much does garage door spring repair cost?
A single torsion spring replacement starts at $249 and a pair starts at $349, including weighing the door, sizing the springs, balancing and testing. Call (425) 728-2403 for a quote.
Is it safe to lift the door while a spring is broken?
Please do not. Without the spring, the full weight of the door is held by the opener or your hands, and it can drop suddenly. Leave it closed and call us.
Do you provide garage door spring repair near Gene Coulon Memorial Beach Park?
Yes. Garage door spring repair is available across Renton, including Fairwood, Maplewood and the Highlands, with no trip fee within our service area. Call (425) 728-2403 or send the form.
Is there a garage door spring repair company near me in Renton?
Yes. We are based on Stone Way North in Seattle, about 13 miles away, and most bookings are scheduled within a day or two.

Book Garage Door Spring Repair in Renton

Call now, or send the form above and we will confirm a window that works for your address.

(425) 728-2403
Call NowFree Quote