Skip to content
3627 Stone Way N #203, Seattle, WA 98103Open daily 8AM–8PM
(425) 728-2403
(425) 728-2403
Nearby city · 10 mi from our office

Garage Door Spring Repair in Redmond, WA

A snapped spring can trap a car and make the door dangerous to lift. We carry the common sizes and usually finish the job in one visit, including in Avondale.

  • Starts at $249 anywhere in Redmond, with the full price in writing first
  • Safety-reverse test before we leave
Call (425) 728-2403All of Seattle

Get Your Free Quote

Written price before any work. We reply during business hours.

Free estimate · You decide after seeing the price

Direct answer · pricing

Garage Door Spring Repair in Redmond starts at $249. There is no trip fee in our service area, and the price you are quoted in writing is the price you pay. Call (425) 728-2403 for an exact quote.

Extension-to-torsion conversionNew shaft, drums, bearings and springs
From $549
Spring adjustment / rebalanceWhen springs are sound but the door is out of balance. Quoted in writing first.
From $129
Single torsion spring replacementDoor weighed, spring sized, balanced and tested
From $249
Pair of torsion springsRecommended on two-spring doors. A common job near Marymoor Park.
From $349
High-cycle spring upgradeRated for roughly twice the cycles
From $399

Why Garage Door Spring Repair Calls Come In from Redmond

Redmond is a city of planned neighborhoods and busy commuters, with most homes built from the 1970s through the 2000s on the hills around the Sammamish River valley. In damp garages, springs rust between the coils, and a rusted spring breaks well before its rated cycle count, so spring calls in Redmond are a steady part of our week.

The weather plays a part: the coldest winter mornings in our area, with frost in the valley and snow on the hills more often than in Seattle. When we replace a spring here, we look at the other spring, the cables and the bottom brackets too, because they have lived through the same winters.

Signs You Need Garage Door Spring Repair in Redmond

The door slams down quickly when released halfway (especially in Education Hill)
One cable is slack or has unwound from its drum
The door closes crooked, with one side lower (common in Avondale and Education Hill)
A loud bang from the garage, like a gunshot, with no obvious cause
A visible gap in the coil of a spring above the door (routine on local jobs)

How Garage Door Spring Repair Works in Redmond

No step is skipped because the schedule is busy. This is the sequence for garage door spring repair in Redmond.

  1. Secure the doorThe door is clamped closed and the opener unplugged before any spring work starts. Same on every local visit.
  2. Weigh and measureThe door is weighed and its height, drum size and existing springs measured to size the new springs correctly.
  3. Unwind and removeRemaining spring tension is released with proper winding bars, never screwdrivers, and the old springs come off.
  4. Install and windNew springs are fitted, wound to the correct number of turns and the cables re-tensioned evenly on both drums. Done the same way near Marymoor Park.
  5. Balance and testThe door is balance-tested by hand, rollers and bearings lubricated, and the opener reconnected and safety-tested.

What We See on Redmond Jobs

Around Marymoor Park, plenty of doors have been replaced or insulated since their springs were fitted. When we weigh those doors, the old springs are often undersized, which is why the opener was struggling before the spring broke.

Smart openers and app control are common here, and many service calls turn out to be connectivity problems rather than mechanical ones: a router moved, a firmware update failed, or the opener lost its link to the app. We check the mechanical side first, because a door that is out of balance will fail whatever the app says, and then sort out the connection.

We quote in writing, test the safety systems on every visit and leave the garage as clean as we found it. That is the whole promise. Call (425) 728-2403.

Garage Door Spring Repair Questions from Redmond

Should I attempt a spring swap on my own?
We strongly advise against it. Torsion springs store enough energy to cause serious injuries, and the job needs proper winding bars and a correctly sized spring.
Should I replace both springs?
On a two-spring door, usually yes, because the second spring has done the same number of cycles. We tell you plainly if the other spring is newer and can stay.
Will a new spring make my opener last longer?
Yes, if the old springs were undersized. A correctly balanced door means the opener is only guiding the door, which is what it was designed to do.
Is it safe to lift the door while a spring is broken?
Please do not. Without the spring, the full weight of the door is held by the opener or your hands, and it can drop suddenly. Leave it closed and call us.
Do you provide garage door spring repair near Marymoor Park?
Yes. Garage door spring repair is available across Redmond, including Bear Creek, Idylwood and Avondale, with no trip fee within our service area. Call (425) 728-2403 or send the form.
Is there a garage door spring repair company near me in Redmond?
Yes. We are based on Stone Way North in Seattle, about 10 miles away, and most bookings are scheduled within a day or two.

Also Serving Nearby

Sorted by distance from this area.

Garage Door Spring Repair in Kirkland3.9 miles awayGarage Door Spring Repair in Bellevue5.8 miles awayGarage Door Spring Repair in Bothell7.2 miles awayGarage Door Spring Repair in Wedgwood, Seattle7.9 miles awayGarage Door Spring Repair in Kenmore8.1 miles awayGarage Door Spring Repair in Ravenna, Seattle8.4 miles away

More here: Garage Door Repair · Garage Door Opener Repair · Garage Door Installation · All Redmond services

Book Garage Door Spring Repair in Redmond

Call now, or send the form above and we will confirm a window that works for your address.

Call (425) 728-2403Request a Quote
(425) 728-2403
Call NowFree Quote